Skip to product information
1 of 3

Decorative-Concrete-Supply

Gorilla Coatings Polyaspartic Coating

Gorilla Coatings Polyaspartic Coating

Regular price $245.00
Regular price $297.00 Sale price $245.00
Sale Sold out

Polyaspartic is a two component 95% solids polyaspartic aliphatic polyaspartic sealer. This material can be used as the base coat and the topcoat over paint chip decorative broadcasts or colored sand broadcasts to provide an infinite array of color schemes or patterns. Polyaspartic has excellent chemical resistance, hardness, abrasion resistance, UV stability and has an excellent clear gardner color. However, the outstanding feature of this product is its quick tack free time for foot traffic.

RECOMMENDED FOR: Recommended for areas where a medium build broadcasted floor is desired and installation downtime is very limited. This material can also be applied over a broadcasted or troweled system as a thin to medium build sealer.

SOLIDS BY WEIGHT: 95% (+/- 1%)

SOLIDS BY VOLUME: 94% (+/-1%)

VOLATILE ORGANIC CONTENT: Less than 50 grams per liter

COLORS AVAILABLE: Clear – gardner color 1-2

RECOMMENDED FILM THICKNESS: 10-15 mils. (when applying directly to concrete, precautions should be taken to properly prepare the substrate and the moisture content of the substrate should be tested. Do not apply to damp surfaces.)

COVERAGE PER GALLON: 107 – 160 sq ft per gallon

PACKAGING INFORMATION: 2.5 gallon kit (other special kit sizes are available upon request. (packaging information is approximate net volume)

MIX RATIO: 12.95 pounds part A to 9.3 pounds part B. The mix ratio is approximately 1.5 gallons part A to 1 gallon part B.

SHELF LIFE: 6 months in unopened containers

FINISH CHARACTERISTICS: Gloss (>70 at 60 degrees @ glossmeter)

COMPRESSIVE STRENGTH: 11,500 psi @ ASTM D695

TENSILE STRENGTH: 3,800 psi @ ASTM D638

ULTIMATE ELONGATION: 2.4% HARDNESS: Shore D= 75

ABRASION RESISTANCE: Taber abraser CS-17 calibrase wheel with 1000 gram total load and 500 cycles= 20 mg loss

ADHESION: 340 psi @ elcometer (concrete failure, no delamination, applied to shotblasted concrete)

VISCOSITY: Mixed= 1,000-2,000 cps (typical)

DOT CLASSIFICATIONS: Part A “not regulated” Part B “not regulated”

PRIMER: Recommend a suitable epoxy broadcasted base system and/or adhesion testing prior to use.

TOPCOAT: Optional: none required

For Safety Data Sheet, Please Download  SDS

For Technical Data Sheet, Please Download TDS

View full details